To install it, use: ansible-galaxy collection install cisco.ios. To check whether it is installed, run ansible-galaxy collection list. I guess we should know all MIB view family names by heart. How in the heck are we supposed to know this. Also, add all objects of the Cisco private MIB. You might already have this collection installed if you are using the ansible package. snmp view On R1, create an SNMP view test via SNMP of all objects in the system group except for system 7 objects. the problem here is that the only attribute for monitoring this "RAS" (in real it's IKEv2-based IPSec VPN tunnel) session is using crasSessionState, but it is returning value "0", which is by definition of crasSessionState is SessionStatus-based attribute with following valid values: initializing(1), established(2) and terminating(3) and "0" therefore is not defined. This module is part of the cisco.ios collection (version 4.3.1). Secondly I've tried snmpwalk over OID 1.3.6.1.4.1.9.9.392 from CISCO-REMOTE-ACCESS-MONITOR-MIB which should be dedicatd for RAS VPN instead, but here, yes, I finally get some info back. First I tried snmpwalk over OID 1.3.6.1.4.1.9.9.171 from dedicated CISCO-IPSEC-FLOW-MONITOR-MIB for monitoring IPSec-based VPN tunnels, but unfortunately I was always getting "No Such Instance currently exists at this OID". SNMP agent code operating with the PPVPN-MPLS-VPN MIB enables a standardized. I am trying to get it from multicontext-enabled Cisco ASA version 9.6(4)20 from VPN dedicated ASA context IP address. VRF information to assist in the management and monitoring of MPLS VPNs. This is an example of snmpwalk on ifTable: snmpget ifDescr.3 ifOperStatus.3 ifAdminStatus.3 ifDescr.3 : DISPLAY STRING: Tunnel0 ifOperStatus.3 : INTEGER: up ifAdminStatus. If Table is polled, you can see the admin or protocol status on that interface. I am fighting to retrieve site-to-site VPN tunnel status via SNMP. A VPN tunnel can be monitored just like any other interface.
0 Comments
Leave a Reply. |